"Angle Boss" Cut-Off Saw Model M-20 by Vista

DESCRIPTION

M-20 machines miter cut up to 75 degrees from 0 (90 degree cut). Cut length on 2 x material with fence at standard position (single point of cut) - 12 inches. Typical cuts are 90 degrees on 2x12s - 30 degrees on 2x10s - 45 degrees on 2x8s - 60 degrees on 2x6s - 70 degrees on 2x4s.

M-20 machines are capable of cutting 2x6s on edge for bevel cuts. 4x4s cut with ease. Our most popular unit, this machine delivers the performance that 75% of customers demand.

Standard Equipment:

20" Carbide Tipped Saw Blade
10 HP, tefc, 3 phase arbor drive motor
2 Hand (non anti-tie down) cycle control
Magnetic starter in dust proof enclosure
Saw access door safety switch
"Quick Adjust Rod" for proper clamp/guard height
Large easy to read scales 0-75 or 90-15 degree
Air filter/regulator/lubricator
Air supply shut off valve
OSHA safety blow gun

Optional Equipment:

Solid or roller infeed & outfeed tables.
Manual & Air operated 4" high x 9" long swing up material stops.
TigerStop automatic material stop gauge complete with interlock kit, table and hardware installed & tested with new machine purchase.
Air over Oil control of saw cutting speed.
Laser light (shows blade position on top surface of work piece with clamp/guard raised)
Anti-tie down cycle control
3 position fence rails - normal ( single point cutting at fence line) - 1-3/4" rearward for center lining 2 x 4s & 2-3/4" rearward for centerline cutting 2 x 6s

Only quality components which are readily available from Vista Machines or any number of supply houses across the country are used in the manufacture of "ANGLE BOSS" cut off saws. Made with pride in the U.S.A.