• image


The Model M-20 Auto-Set machine was developed to satisfy one or more of the following:

  • Cut list runs are extremely short (less than 6 pieces) between angle set-ups.
  • Removal of possible operator error when adjusting for angle settings.
  • Easiest and quickest possible method of machine adjustment.

M-20 Auto-Set machines miter cut up to 75 degrees from 0 (90 degree cut). Cut length on 2 x material with fence at standard position (single point of cut) - 12 inches. Typical cuts are 90 deg. on 2x12s - 30 deg. on 2x10s - 45 deg. on 2x8s - 60 deg. on 2x6s - 70 deg. on 2x4s. M-20 Auto-Set machines are capable of cutting 2x6s on edge for bevel cuts. 4x4s cut with ease.


In the Single Angle mode the angle adjustment setting is entered into the operator interface keypad. When the "Enter" key is depressed, the table rotates to position. Machine is now ready to cut. Operator pushes palm button located on top of clamp/guard assembly. This brings the clamp/guard assembly down onto work piece. While holding this button, operator pushes second button located at either side of machine. This cycles the blade up & down to make the cut. This method of operation ensures the operator cannot have a hand or finger in the cutting area of the machine. Releasing either button at any time lowers the blade below the table and then raises the clamp/guard assembly.

In the Multi Angle mode, the operator can input up to 6 different angle settings into the controller. After each cut cycle is completed, the table will automatically rotate to the next programmed angle setting.

Standard Features:
  • Operator input selectable for either single or multiple (up to 6) angle cuts
  • 20" Carbide Tipped Saw Blade
  • 10 HP, tefc, 3 phase arbor drive motor
  • Magnetic starter in dust proof enclosure
  • 2 Hand (non anti-tie down) cycle control
  • Saw access door safety switch
  • "Quick Adjust Rod" for proper clamp/guard height
  • Same point of cut at fence line, regardless of angle setting
  • Micro-Step Drive, controller & operator panel for angle adjustments
  • Auto-Lube table
  • Air filter/regulator/lubricator
  • Air supply shut off valve with lock-out ring
  • OSHA safety blow gun


Optional Equipment:
  • Solid or roller infeed & outfeed tables.
  • Manual & Air operated 4" high x 9" long swing up material stops.
  • TigerStop automatic material stop gauge complete with interlock kit, table and hardware installed & tested with new machine purchase.
  • Air over Oil control of saw cutting speed.
  • Laser light (shows blade position on top surface of work piece with clamp/guard raised)
  • Anti-tie down cycle control

Only quality components which are readily available from Vista Machines or any number of supply houses across the country are used in the manufacture of "ANGLE BOSS" cut off saws. Made with pride in the U.S.A.